某型电动飞机螺旋桨振动特性实验研究

某型电动飞机采用螺旋桨产生拉力,为了防止螺旋桨工作时共振,利用ES-2-150振动实验系统进行了两叶木质螺旋桨和碳纤维螺旋桨的振动特性实验,采用谐振搜索与驻留方法测量出木质螺旋桨的第一阶固有频率为36.07Hz,碳纤维螺旋桨的第一阶固有频率为73.58Hz。螺旋桨爬升状态转频为39Hz,这与木质螺旋桨的第一阶固有频率非常接近,导致木质螺旋桨在爬升状态出现比较严重的振动故障。因此,某型电动飞机最终选择两叶碳纤维螺旋桨作为其拉力产生装置。     

螺栓松动边界下纤维增强复合薄板的振动测试方法

提出了基于预埋压力传感器的量化测试方法,研究了螺栓松动边界对纤维增强复合薄板振动特性的影响。首先,自主设计并开发了带有预埋压力传感器的螺栓松动边界下复合薄板的振动测试系统,并详细介绍了系统各个部件的组成和功能;然后,归纳出一套合理、规范的松动边界下复合薄板的振动测试流程,并对HF10碳纤维/树脂复合薄板进行了实际测试。结果表明:随着螺栓松动程度的不断增加,复合薄板的固有频率逐渐降低,模态振型的节线位置也发生了不同程度的变化,但其阻尼结果呈现先增大后减小的趋势;而共振和非共振响应呈现先减小后增大的趋势。     

粉末晶体(ZrO2)x(Bi2O3)1-x(x=1.0, 0.97) 晶体结构分析

为了确定ZrO2和(ZrO2)0.97(Bi2O3)0.03的晶体结构和原子热振动各向同性温度因子B，对该粉末晶体进行X射线衍射实验，建立了晶体结构模型，进行晶体结构分析。首先，采用共沉淀法和高温固相烧结法制备了纳米氧化锆ZrO2和(ZrO2)0.97(Bi2O3)0.03粉末晶体，接着，使用X射线测试仪对两种样品进行了衍射实验（XRD），利用Rietveld 精修方法的 RIETAN-2000程序对所得实验结果进行了晶体结构分析，获得了晶体结构参量和原子热振动各向同性温度因子B。通过Maximum Entropy Method（MEM）解析得到了粉末晶体(ZrO2)x(Bi2O3)1-x(x=1.0，0.97)的等高电子密度分布可视化图谱。结果表明，(ZrO2)0.97(Bi2O3)0.03的晶胞体积比ZrO2的晶胞体积大分别为140.6850 Å3和140.5637Å3；ZrO2晶体的原子热振动各向同性温度因子B(Zr)、BO(1)、BO(2)和 B（Bi）分别为0.690、0.269、 0.178 和 0 Å2，(ZrO2)0.97(Bi2O3)0.03晶体的分别为0.460 、0.583 、0.121 和0.581 Å2。 确定了(ZrO2)0.97(Bi2O3)0.03的晶体结构属于单斜晶系，实现了等高电子密度分布三维（3D）和二维（2D）的可视化，进一步确定了晶体结构和原子位置。     

Synthesis,Structures, and Properties of Highly Strained Cyclophenylene–Ethynylenes with Axial and Helical Chirality

Single and double cyclophenylene–ethynylenes (CPEs) with axial and helical chirality have been synthesized by the Sonogashira cross-coupling of di- and tetraethynyl biphenyls with a U-shaped prearomatic diiodoparaphenylene followed by reductive aromatization. X-ray crystallographic analyses and DFT calculations revealed that the CPEs possess highly twisted bent structures. Bend angles on the edge of the paraphenylene units were close to the value of [5]cycloparaphenylene (CPP)—the smallest CPP to date. The double and single CPEs possessed stable chirality despite flexible biphenyl structures because of the high strain in the diethynyl–paraphenylene moiety. In both the single and double CPEs, orbital interactions along the biphenyl axis were observed by DFT calculations in LUMO and LUMO+2 of the single CPE and LUMO+1 of the double CPE, which likely cause lowering of these orbital energies. Concerning chiroptical properties: boosting of the g_abs value was observed in the biphenyl-based double CPE, as well as the binaphthyl-based single CPE, compared to the biphenyl-based single CPE.     

Control of Axial Chirality by Planar Chirality Based on Optically Active [2.2]Paracyclophane

Optically active X-shaped molecules based on the planar chiral [2.2]paracyclophane building block were prepared, in which di(methoxy)terphenyl units were stacked on the central benzene rings. At 25 °C, anisolyl rings freely rotate in solution, while in the crystal form, they are fixed by intramolecular CH–π interactions, thereby leading to the expression of the axial chirality, i.e., propeller chirality was exhibited by the planar chiral [2.2]paracyclophane moiety. The X-shaped molecule exhibited good circularly polarized luminescence (CPL) profiles with moderate Φ_PL and a large g_lum value in the order of 10⁻³ at 25 °C, in solution. In contrast, at −120 °C, dual CPL emission with opposite signs was observed. According to the theoretical studies, the rotary motion of the anisolyl units is suppressed in the excited states, and so emission from two isomers could be observed. These results demonstrate that the axial chirality was controlled by the planar chirality, leading ultimately to propeller chirality.     

Vibrations of a continuous web on elastic supports

We consider an infinite, homogenous linearly elastic beam resting on a system of linearly elastic supports, as an idealized model for a paper web in the middle of a cylinder-based dryer section. We obtain closed-form analytical expressions for the eigenfrequencies and the eigenmodes. The frequencies increase as the support rigidity is increased. Each frequency is bounded from above by the solution with absolutely rigid supports, and from below by the solution in the limit of vanishing support rigidity. Thus in a real system, the natural frequencies will be lower than predicted by commonly used models with rigid supports.     

基于Rietveld精修方法解析Bi2O3的原子热振动

三氧化二铋(Bi₂O₃)是氧离子导电体,为了获得它的原子热振动各向同性温度因子,对该粉末晶体进行X射线衍射实验,建立了晶体结构模型,利用Rietveld 精修方法的RIETAN-2000 程序对所得实验结果进行了晶体结构精修,通过最大熵方法(MEM)解析得到了粉末晶体的等高电子密度分布三维(3D) 和二维(2D)可视化图谱。结果表明,各原子Bi₍₁₎、Bi₍₂₎、O₍₁₎、O₍₂₎和O₍₃₎的原子热振动各向同性温度因子分别为0.004 938 nm²、0.004 174 nm²、0.007 344 nm²、0.007 462 nm²、和0.007 857 nm²,等高电子密度分布的可视化,进一步验证了晶体结构模型和原子位置的准确性,这些参数对研究晶体材料的热性质具有一定参考意义。     

田字形地震超材料甚低频宽带隙机理

在地球中传播的地震波主要有体波和表面波,而表面波中Rayleigh波对建筑物造成的破坏最为强烈。针对Rayleigh波的振动控制,提出一种田字形超材料结构。相比于传统的地震超材料,这种超材料屏障是由外部口字形框体内部嵌套十字形柱体组成,形成4个可填充区域,其外部框体采用部分埋入的方式,具有高强度、强稳定性、填充方式灵活的特点。应用有限元法计算了田字形超材料的能带结构和传输特性,并通过分析带隙边界处模态振型可知,带隙的打开是由于柱体的局域共振。结合带隙机理可知,柱体结构中土壤填充量不同可改变柱体的质量,形成不同的谐振频率,产生甚低频带隙。为进一步拓宽带隙,设计研究了正、负梯度的质量填充方式,均可得到3.3~13.1 Hz甚低频宽带隙,在谐振频率范围内两者的隔震方式分别为Rayleigh波彩虹捕获和Rayleigh波到体波的转化。最后,采用EI-Centro地震波对填充屏障进行了时程验证,加速度最大幅值衰减超过80%,为地震超材料在减震隔震方面应用提供了新的设计思路和方法。     

Dual effects of ultrasound on fabrication of anodic aluminum oxide

Ultrasound has been proven to enhance the mass transfer process and impact the fabrication of anodic aluminum oxide (AAO). However, the different effects of ultrasound propagating in different media make the specific target and process of ultrasound in AAO remain unclear, and the effects of ultrasound on AAO reported in previous studies are contradictory. These uncertainties have greatly limited the application of ultrasonic-assisted anodization (UAA) in practice. In this study, the bubble desorption and mass transfer enhancement effects were decoupled based on an anodizing system with focused ultrasound, such that the dual effects of ultrasound on different targets were distinguished. The results showed that ultrasound has the dual effects on AAO fabrication. Specifically, ultrasound focused on the anode has a nanopore-expansion effect on AAO, leading to a 12.24 % improvement in fabrication efficiency. This was attributed to the promotion of interfacial ion migration through ultrasonic-induced high-frequency vibrational bubble desorption. However, AAO nanopores were observed to shrink when ultrasound was focused on the electrolyte, accompanied by a 25.85 % reduction in fabrication efficiency. The effects of ultrasound on mass transfer through jet cavitation appeared to be the reason for this phenomenon. This study resolved the paradoxical phenomena of UAA in previous studies and is expected to guide AAO application in electrochemistry and surface treatments.     

Manipulation with sound and vibration: A review on the micromanipulation system based on sub-MHz acoustic waves

Manipulation of micro-objects have been playing an essential role in biochemical analysis or clinical diagnostics. Among the diverse technologies for micromanipulation, acoustic methods show the advantages of good biocompatibility, wide tunability, a label-free and contactless manner. Thus, acoustic micromanipulations have been widely exploited in micro-analysis systems. In this article, we reviewed the acoustic micromanipulation systems that were actuated by sub-MHz acoustic waves. In contrast to the high-frequency range, the acoustic microsystems operating at sub-MHz acoustic frequency are more accessible, whose acoustic sources are at low cost and even available from daily acoustic devices (e.g. buzzers, speakers, piezoelectric plates). The broad availability, with the addition of the advantages of acoustic micromanipulation, make sub-MHz microsystems promising for a variety of biomedical applications. Here, we review recent progresses in sub-MHz acoustic micromanipulation technologies, focusing on their applications in biomedical fields. These technologies are based on the basic acoustic phenomenon, such as cavitation, acoustic radiation force, and acoustic streaming. And categorized by their applications, we introduce these systems for mixing, pumping and droplet generation, separation and enrichment, patterning, rotation, propulsion and actuation. The diverse applications of these systems hold great promise for a wide range of enhancements in biomedicines and attract increasing interest for further investigation.